The deep Hunter Jumper saddle is designed for jumping. It correctly aligns the rider's pelvis and provides rider balance close to the horse's centre of gravity and an optimum close contact feel.
For the rider, saddle SE06 provides a feeling of permanent contact with the horse which allows him to have more precise actions. Contact is unparalleled and has been worked on with a lower cut of the saddle flap around the stirrup bars (only one layer of leather under the skirt).
For the horse, the wide panels are concave and integrated for better distribution of the saddle’s pressure along the horse's back.
The saddle opening around the shoulders frees up the horse's movements. The three-point girthing system distributes pressure along the horse's back for better performance.
In order to protect the leather, it is essential to initially oil your saddle. At CWD, we carry out this process before delivering your made-to-measure saddle. No additional treatment is needed, and you can use it as soon as you receive it.
Beware of the risk of staining white clothes, especially during the first few uses.
Our accessories are delivered without having been oiled. Apply a large quantity of CWD oil or conditioner evenly and repeat if necessary to obtain the desired suppleness. Use the CWD glove to massage any excess conditioner into the leather. If possible, let the leather absorb the CWD conditioner for 24 hours in a well-ventilated room. Natural leathers will darken before lightening slightly to reach their definitive shade.span>
Before oiling or greasing your accessories, make sure to try them on your horse first. Accessories which have been greased cannot be returned.
STEP 1 : CARE
Care for your equipment regularly with a damp sponge and glycerine soap to retain a soft, solid leather.
Saddles & tack : Clean all your equipment every day.
STEP 2 : NOURISH
Oil with our balm, using the CWD glove. Adjust how often you do this depending on the seasons and poor weather. (c.f. expert advice).
Saddles : Start with the underside of the pads (excluding the billet straps), then the top side and finish with the seat. Renew once or twice a year.
Tack : Oil it once or twice a year. Adjust according to the products: for boots and girths, direct contact with water or sand may mean more regular oiling is required.
N.B.: All our saddles are oiled before they leave the workshop. Do not oil them before the first use. For tack, remember to try it before oiling it.
In summer, after each use, the leather needs to be treated to compensate for and repair the drying out caused by the sun and high temperatures.
In winter, a heated area is needed to combat the ambient humidity, which is damaging to its lifespan and can be a source of mould.
Avoid the following. As far as possible, avoid cleaning your leathers with products which contain solvents which will prematurely discolour the saddle and will dry out the leather fibres.
Tip. If your saddle has been in contact with water, dry the leather carefully by placing it in a warm room. Once dry, clean it and apply the CWD conditioner.
Be careful! Do not grease a saddle which has not been cleaned first: you risk letting the dirt penetrate into the leather, damaging its appearance and shine.